6
© 2009 Directed Electronics. All rights reserved.
2 GREEN STARTER - NORMALLY OPEN (MOTOR SIDE)
3 GREEN/BLACK STARTER - NORMALLY CLOSED (MOTOR SIDE)
GWA Mux Harness, 3-pin connector
1 RED +12 VDC TO SENSOR
2 BLACK GND TO SENSOR
3 BLUE/WHITE MUX WIRE INPUT
Adjusting the Shock Sensor
Using the 2-way remote control:
Disarm1. the system, turn the ignition off and close all the doors, hood and trunk.
Press2. and hold the
button of the remote control until a long beep is emitted and
Main Menu
is dis-
played. (if programmed to operate two systems, ignore the car 1 or car 2 text and beeps at 3 seconds).
Release3. the
button to view the main menu.
Setup Remote
is displayed.
Press4. and release the
button.
Sensor Adjust
is displayed.
Press5. and hold the
button until a long beep is emitted and the siren emits a long chirp. The current
sensitivity
Sen ##
is displayed, adjustment mode is ready.
Adjust the sensitivity:6.
a. Press and release the
and
buttons change the sensitivity.
b. Press and hold the
button. The adjustment is sent to the system and the remote control emits a long
beep as confirmation.
c. Release the button.
Note: After each adjustment the sensitivity can be tested by cautiously impacting the vehicle with increasing
intensity. The siren will chirp to indicate the impact level required to fully trigger the alarm.
Exit adjustment mode:
Press• and release the
or
button any time.
Open• the hood or trunk
Turn• the ignition on
Wait for 30 seconds between steps•
The siren will emit one long chirp when exiting adjustment mode.
Adjusting the sensor with the 1way remote:
Disarm the system, turn the ignition Off and close all the doors.1.
Press and hold the 2.
button of the remote control for 8 seconds until the transmit LED turns on then release
it (If programmed to operate two systems, ignore the transmit LED flashes at three seconds).
Press and hold the 3.
button until the transmit LED flashes off then on and the siren emits a long chirp.
Adjustment mode is ready.
Adjust the sensitivity:4.
Press• and release the
button to increase the sensitivity. The siren chirps two times.
Press • and release the
button to decrease the sensitivity. The siren chirps one time.
Press• and release the
button to reset sensitivity to default setting. The siren chirps three times.
Note: After each adjustment the sensitivity can be tested by cautiously impacting the vehicle with increasing
intensity. The siren will chirp to indicate the impact level required to fully trigger the alarm.
Exit adjustment mode:
Press• and release the
button any time to exit adjustment mode, and then press and hold to return the
remote control to normal operation (transmit LED turns off).
Open• the hood or trunk
Turn• the ignition on
Wait for 30 seconds between steps•
The siren will emit one long chirp when exiting adjustment mode.
(36 strony)
(19 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji